All of the DRAM and high-bandwidth memory that Samsung, SK hynix and Micron plan to make in 2027 has reportedly been committed, according to DigiTimes, which cited industry sources. Buyers signed multi-year agreements at prices well above this year's levels, leaving little spot supply for anyone who did not book early.
A shortage built into the product
HBM is stacks of DRAM wired vertically behind an AI accelerator. Making it consumes far more wafer area per bit than ordinary memory, so every HBM order removes capacity that would otherwise go to laptops, phones and cars. TrendForce puts the trade ratio high enough that a doubling of HBM output can absorb capacity without adding a single usable bit elsewhere.
The price data show the squeeze. Contract prices for a 16-gigabit DDR5 chip climbed from about $8.70 in October 2025 to $48 in September 2026, more than five times higher, according to figures cited by Tom's Hardware. Some server memory trades 30 to 50 percent above contract on the spot market.
The earnings test lands Tuesday
Nvidia reports fiscal third-quarter results after the close on Tuesday, with its shares roughly 30 percent below their peak and almost $2 trillion of market value gone in a little over a month. The company has said it wants to double accelerator output; memory suppliers are the ceiling on that promise, not TSMC's wafer starts.
SK hynix has warned that tightness runs through 2027 and into 2028, when new fabs come online. Samsung has said much the same. Neither can shorten the two to three years it takes to build and ramp a memory fab, and both prefer HBM because the margins are better.
Who pays
The bill lands on everyone downstream. PC makers are already passing higher memory costs into retail prices, and phone makers are cutting memory configurations to hold price points. Cloud operators have locked in supply, which protects them and leaves smaller buyers bidding.
For the AI build-out, the practical question is not whether demand exists but how many accelerators can be assembled and shipped with memory attached. On current bookings, that number is fixed well before any new capacity arrives.
---
Reliable Ferrofluid Vacuum Rotary Feedthrough for Semiconductor Manufacturing
In semiconductor manufacturing, maintaining ultra-high vacuum integrity during rotary motion is critical — from single silicon crystal growth and CVD to sputtering and plasma etching. Ferrofluid Vacuum Rotary Shaft Feedthrough from FerrofluidTec delivers hermetically sealed rotary feedthroughs with leakage rates as low as 10⁻¹² Pa·m³·s⁻¹, vacuum degree up to 10⁻⁶ Pa, and customizable shaft diameters from 10mm to 100mm. Built with non-magnetic stainless steel housings and magnetic permeability stainless steel shafts, these feedthroughs provide reliable, maintenance-free sealing for demanding vacuum environments. Visit www.ferrofluidtec.com to learn more.